Disco-DAW4110

Narrow kerf width and small corner radius

DAW4110 is capable of cutting inner corners with a radius, R, of 0.3 mm by achieving a 0.3 mm kerf width using the waterjet saw. Thus, the equipment is suitable for processing narrow sections.

Abrasive recycling

Employs a recycling system to collect and recycle abrasives without drying using　a premixing system.

Cuts workpieces with contour dimensions from input data

Using the automatic tool correction function, the DAW4110 can correct input data, according to measured values for the 

Processing example

Cutting glass epoxy substrate with copper wiring

Supports the separation of multilayer substrates with an insulation layer thickness of less than 100 µm, such as Low-K films. Improves yield and contributes to lower cutting costs because burring and smearing are minimized.

Cutting titanium

Capable of cutting materials susceptible to cutting defects caused by processing heat, such as titanium and stainless steel.

Workability target

* Actual workability depends on the workpiece.
* The vertical cross-section surface and surface roughness may not be applicable for important workpieces.
* Partial cuts and the processing of very hard materials is not possible (such as grooving or concave processing)
* For details, please contact your local sales representative.

 *Product appearance, features, specifications, and other details may change due to technical modifications.
*Please read the standard specification sheet thoroughly before use.