StayClean Injector
Back to: Optional Accessories
Disco
Dedicated unit for injecting StayClean into cutting water
Highly accurate dilution control to ratios as low as 1:10,000.
• Automatic bottle replacement enables continuous operation.
Highly accurate dilution control to ratios as low as 1:10,000.
• Automatic bottle replacement enables continuous operation.
Environmental Conditions:
- Use clean, oil-free air (dew point between -10 - -20 , residual oil: 0.1 ppm, and filtration rating: 0.01μm/99.5 % or more).
- Keep room temperature fluctuations within ±1℃ of the set value. (Set value should be between 20 - 25 ℃).
- Keep cutting water and cleaning water 2 ℃ above room temperature (fluctuations within ±1 ℃).
- The machines should be used in an environment, free from external vibration. Do not install machine near a ventilation opening, heat generation equipment or oil mist generating parts.
- This machine uses water. In case of water leakage, please install the machine on the floor with sufficient waterproofing and drainage treatments.
- All pressures specified above are gauge pressures.
- As the above specification may change due to technical modifications. Please confirm when placing your order.
- For further information, please contact your local sales representative.
Related Products
Back to Optional Accessories
Disco
StayClean-R
Conserving Water While Preventing Corrosion Prevents Corrosionby DI water The active component in StayClean-R continuous…
Disco
Non contact setup
Blade tip position relative to the chuck table surface is detected by an optical sensor. Processing quality is stable si…
Disco
Blade breakage sensor
Processing is stopped immediately if blade breakage occurs to minimize potential workpiece damage.
Disco
Ultrasonic-wave dicing unit
Realizes high quality and high speed processing of difficult-to-cut materials Targets for ultrasonic-wave processing Ult…